Pimoroni HyperPixel - 4.0" Hi-Res Display for Raspberry Pi

Pimoroni's HyperPixel features a 4.0" display with 800x480 18-bit HyperPixel 4.0" is designed to fit nicely onto the Raspberry Pi Zero, Pi 3, Pi 2 or Model A+ / B+ (any Pi with a 2x20 connector). Not for use with the old Pi 1 with 2x13 connector. If you'd like to use a 3.5" display with the original Pi A or Pi B, check out the SPI-based PiTFT 3.5"

Everything comes fully assembled, so there's no soldering required! The display secures to the HyperPixel PCB via a neat little flush-mounting FPC cable. Just pop HyperPixel on your Pi and run the installer to get set up!

Works with any 40-pin version of the Pi, including Pi Zero and Pi Zero W. If you're using it with a larger Pi like the B+, 2, or 3, then use the extra 40-pin header that's included to boost it up to the required height. If you're using a Zero or Zero W then just pop it straight onto the GPI.

Features

High-speed DPI interface

4.0" IPS (wide viewing angle, 160°) display (86.4x51.8mm)

800x480 pixels (~235 PPI)

18-bit (that's 262,144 when installing HyperPixel onto your Pi, make sure not to press down on the screen surface. Hold the board by its edges and wiggle it to the extended header (or GPIO header).

We also carry its capacitive touch "cousin"!