-
Your shopping cart is empty!
UMFT230XB-01 USB to UART Breakout Module, USB Battery Charger Detection, 300baud to 3Mbaud at TTL Levels
- SKU: UMFT230XB-01
UMFT230XB-01 breakout module utilizes FT230XQ IC to convert USB to basic UART module. UMFT230XB bridges from USB to UART IC. This hardware is a low cost breakout board form factor that converts USB2.0 full speed to a serial interface and connects the serial signals to a 2.54mm (0.1inch) pitch 10pin female receptacle. The boards do not use a USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector.
Single chip USB to asynchronous serial data transfer interface
Entire USB protocol handled on the chip. No USB specific firmware programming required
Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
Configurable CBUS I/O pin
Device supplied preprogrammed with unique USB serial number
Supports bus powered, self powered and high power bus powered USB configurations
Integrated power on reset circuit
Low USB bandwidth consumption
UHCI/OHCI/EHCI host controller compatible
USB 2.0 full speed compatible