Filament dryer SpacePi X4 for 4 spools 45°-85° Creality

The Creality SpacePi X4 is a powerful dual-chamber filament dryer that allows you to dry up to 4 spools at once, with a fully adjustable temperature range from 45 to 85 °C. Thanks to its active drying technology, rapid heating, and quiet operation, you can prepare PLA, PETG, TPU, ABS, or PA-CF filaments for printing in a reproducible and stable manner, eliminating problems with moisture, bubbles, and stringing during printing.

Dry different filaments
The device features two independently controlled heaters, allowing you to set different temperatures for different filaments (e.g., 50 °C for PLA and 85 °C for PA-CF). You can use one or both chambers as needed, which saves time and energy in a small workshop or when working with different materials simultaneously.

Speed and uniformity
With 200W + 200W PTC heaters, the SpacePi X4 heats up to 85 °C in about 20 minutes. The 360° air circulation ensures even heat distribution, and the SpaceDry 4.0 technology with active air drying and desiccant regeneration provides efficient moisture removal without needing to replace cartridges.

Quiet, affordable, efficient
The Active Silent system keeps the noise level at just 43-46 dB, allowing you to work comfortably both at home and in the workshop. The Creality SpacePi X4 offers energy-efficient operation with a power consumption of 0.124 kWh in single-chamber mode and 0.208 kWh in dual-chamber mode, reducing the cost of preparing filaments for printing.

Wide compatibility
The Creality SpacePi X4 filament dryer supports spools up to 200 mm in diameter and 150 mm in width, with filaments of 1.75 mm and 2.85 mm diameters. This means you can dry both standard 1 kg spools and larger 2 kg spools.

Safe operation
The Creality SpacePi X4's triple protection system includes fan control, heater temperature protection, and sensors that monitor the temperature in the chambers. This allows you to use the device without worrying about overheating or damaging the filaments.

Everyday convenience
The dryer is equipped with chamber backlighting, a sliding lock, anti-scald rollers, and a moisture-proof seal to ensure convenience. Additionally, the device signals the end of the drying process with an audible alert, making it easy to use.

You control it as you wish
The EDry UI panel allows you to precisely control drying parameters, including temperature, drying time (1-48 hours), and threshold humidity. You can use automatic modes or custom settings to tailor the drying process to the requirements of your specific filament.

Included in the set:
Filament dryer
Power cord
User manual