ECell: Breadboard-Plugin Components Pack

SKU:KIT0098
ECell: Breadboard-Plugin Components Pack
Image is for illustrative purposes only

Breadboard-Plugin Components Pack is a new kit designed for breadboard experiment. It provides many kinds of components, such as resistors, capacitors, diodes, transistor .etc. The module pins are using gold-plating technology, solid and durable. It could be plugged on the breadboard directly. easy, reliable and reusable.

This innovative approach will solve the following issues caused by using DIP type of components:

    Hard to read the value (Resistor    Severe deformations of the pin after used, non-reusable, not environment-friendly
    The pin diameter is too thin or too thick, poor match with the breadboard hole
    Confused the order of transistor “e”, “b”, “c” pins
    Usage problem: Most of sensors and actuators require 3 interfaces: Signal/VCC/GND, you have to use the jumper wire for the connection, messy and unreliable.

    Resistor: 220R,1K,4.7K,10K
    Capacitor: 22pF@50V,100nF(0.1uF)@50V,47uF@10V
    LED: Red, Yellow, Blue, Green
    Diode: If=1A, Vfm=0.7V, Vr=40V
    Transistor-NPN: Vceo=45V, Ic=500mA, hFE=400
    Transistor-PNP: Vceo=-45V, Ic=-500mA, hFE=400

In the same category