Teie ostukorv on tühi!
Puutelüliti 230V, Exta Free
WDN-03 on puutelüliti 230v valgustite sisse/välja lülitamiseks.
The WDN-03 touch switch is used to switch on or switch off the light by means of a touch. It is equipped in one 230 V AC output. WDN-03 switch is used to control the traditional lighting source (halogens, incandescent lighting, fluorescent) or LED diodes. Maximum power supply that can be connected to the voltage output of the switch should not exceed 300 W (for traditional light bulbs). In case of low-voltage light sources (12 V AC halogens, LED diodes) it is necessary to connect a transformer / a power supply to the WDN-03 touch switch with an appropriate power input. WDN-03 has an automatic calibration process during the change of sensor's connection place or the touch surface. This allows the switch sensor to be connected to larger conductive surfaces. In addition, the applied construction solutions allow for a safe use of WDN-03 switch even by persons with an implanted artificial pacemaker. WDN-01 touch switch is designed to be mounted on surfaces such as wood and wood-based imitation materials thicker than 2 mm, and they are also designed for plasterboard mounting. The touch switch fulfils the requirements of harmonized standards in the scope of safety use or electromagnetic compatibility.
Power supply 230 V AC
Supply voltage tolerance -15 ÷ +10 %
Nominal frequency 50 Hz
Power consumption 0,9 W
Number o channels 1
Type of The output Voltage 230 V AC
Output circuit nominal load 300 W
Relay contact 1xNO 5 A / 250 V AC 1250 VA AC1
Sensor’s length 1,5 m
Section of connecting cables Up to 2,5 mm2
Ambient temperature range -10° ÷ +55 °C
Protection degree IP20
Overvoltage category II
Dimensions [mm] 44 x 108 x 33
Weight [g] 60
|Manual WDN-03 GB||103.67KB||Lae alla|